Furuno PP-510 Printer
December 18, 2019
SAILOR 6150 mini-C Distress
December 18, 2019

Boat printer

Replacement Kit : NKG-950 AC
Categories: ,
Description

Specification

DIP Switch Settings

The SEIKOSHA SP-2400AI & SP-2415AI printers use the following Dip Switch settings. Please refer to the printer manual for details of how to set these printers up.

Note: The printer must be turned off before you can change any of the switches. The current DIP Switch settings can be printed by holding down the NLQ switch whilst turning the printer on.

If you have been printing, allow the Print head to cool down before touching it. When setting the switches (below), open the printer cover, remove the ribbon cassette and replace the printer cover. The DIP switches are only read after the initialisation process either by turning the printer on or by receiving the INITIAL signal via the Parallel Interface.

Switch Function Description On Off
1-11-2

1-3

International Character see table
1-4 Epson/IBM mode Selection IBM Epson
1-5 Character set Selection in IBM modeCharacter set Selection in Epson mode. Character Set 2Graphic Character Set 1Italic
1-6 Page Length 12 inches 11 inches
1-7 LF Code Selection in IBM modeDC1/DC3 Code Selection in Epson mode LF + CRInvalid LF onlyValid
1-8 CR Code Selection in IBM modeCR Code Selection in Epson mode CR + LFCR + LF CR onlyAUTOFEED
Note 1 : Epson and IBM modes are selected only by using DIP switch 1-4. There is no control code to designate Epson or IBM mode.

Note 2 : DC1 Code – Select printer through software

DC3 Code – Deselect printer through software

International Character Selection

Country Dip Switch1-1 Dip Switch1-2 Dip Switch1-3
U.S.A OFF OFF OFF
FRANCE OFF OFF ON
GERMANY OFF ON OFF
U.K OFF ON ON
DENMARK ON OFF OFF
SWEDEN ON OFF ON
ITALY ON ON OFF
SPAIN ON ON ON
Dip Switch Bank 2

If Dip Switch 2-7 is OFF (Parallel) then switches 2-1 through to 2-6 (Serial protocol) are ignored

Serial protocol selection

DIP Switch 1200 bps 2400 bps 4800 bps 9600 bps
2-1 OFF ON OFF ON
2-2 OFF OFF ON ON
DIP Switch X-ON/X-OFF READY/BUSY
2-3 ON OFF

Parity selection

DIP Switch No Parity Odd Parity Even Parity
2-4 OFF ON ON
2-5 OFF or ON OFF ON

Serial data length

DIP Switch 7 bits 8 bits
2-6 ON OFF

Interface mode selection

DIP Switch Serial Parallel
2-7 ON OFF

CSF mode selection

DIP Switch Selected Not Selected
2-8 ON OFF
The following Test Prints are available on this printer. Turn Power on whilst holding down the following switch.

LF/FF Switch Self Test ASCII
NLQ Current Dip Switch settings
P.PARK Hexadecimal dump
To exit from the self test mode or current Dip Switch settings, press the ON-LINE switch or turn the power off. To exit from Hexadecimal dump mode either turn the printer off or send an INITIAL signal via the Parallel Interface.

Discreption

Discontiued product. 已经停产。

Replacement model : NKG-950

替代型号:NKG-950

Reviews (0)

Reviews

There are no reviews yet.

Be the first to review “Boat printer”

Your email address will not be published. Required fields are marked *